Dolby Laboratories Atmos Manual do Utilizador descarregar pdf (Página 81)

Navigating the Panner Plug-in Window

Authoring for Dolby

Atmos

™

Cinema Sound Manual 73

• Zones selector: This selector lets you select one of six common speaker zone layouts,

in order to activate or deactivate specific speaker zones (for example, to isolate or

dedicate an object to a specific group of speakers).

5.3.4 X/Y/Z Sliders and Position Displays

The X, Y, and Z sliders allow for using a mouse to adjust the location of the object in all

three dimensions: x (left/right), y (front/back), and z (top/bottom). You can also use a

joystick, control surface, iPad, enabled automation, or keyboard to adjust the location. As

the

X, Y, and Z sliders or position display values are adjusted, the pan location cursor in

the virtual room moves accordingly. Inversely, the

X, Y, and Z sliders and position display

values update when the cursor is adjusted.

You can place or pan an object from any location in the Panner virtual room to any other

location. The

X and Y sliders have a range of –100 to 100. The Z slider range is 0 to 100.

When Elevation mode is off (elevation button not highlighted), you can adjust x and y

coordinates, but you cannot adjust the z coordinate. When Elevation mode is on, you can

also adjust the z dimension. In Ceiling and Wedge Elevation Snap modes, the z

coordinate is generated from the y coordinate only, and changes as the y coordinate is

changed. In Sphere Elevation Snap mode, the z coordinate is generated from x and y

coordinates, and changes as they are changed.

Respective x, y, and z position displays provide the value (or coordinates) of the current

object position in the virtual room, whether moving the pan location with a joystick,

control surface, iPad, mouse, enabled automation, or keyboard entry.

Note:

If the

X, Y, and Z sliders and their position displays are not visible at the

bottom of the plug-in window, click the

Done button in the Configuration

Options

section to close the options and reveal the sliders and their values.

To change object location using a slider and a mouse, do one of the following:

• In a slider, click the slider button and drag to the desired coordinate.

• In a slider, click in the slider range to jump to a new coordinate.

To change object location for a slider by using a keyboard:

• Type a valid value in a slider position display, and press <Enter>.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 130 131

Sem comentários

Dolby Laboratories Atmos Manual do Utilizador Página 81