Dolby Laboratories DM100 Manual do Utilizador descarregar pdf (Página 10)

Dolby

DM100 User’s Manual Getting Started

2-2

Dead Battery…

[Power] Button

To turn on the DM100, press and hold the [Power] button down

for two seconds. The display reads as shown for approximately

one second while a self-test diagnostic runs.

The power-on process ends with the DM100 operating in the

last-used state. If the diagnostic test fails, the Error LED lights

and an error message is displayed.

To turn off the DM100, press [Power] again. The display reads

“Power Off” and the unit shuts off.

Note: Any changes made to the system settings may be lost if the unit is

powered off by unplugging the external power supply, unless batteries

are installed.

Battery Low LED

The front-panel battery LED flashes when the

batteries are nearly discharged. If the battery

voltage drops below a usable level, the

DM100 display reads “Dead Battery” and the

unit shuts off.

Auto-Power Off

When the DM100 is powered from batteries (external power

supply not connected), the unit can be set to turn itself off after a

selectable number of minutes with no user activity (5, 10, 15, or

30 minutes). This feature can be disabled. The factory default

setting is 15 minutes.

The wait time is set from the Setup menu under System Settings,

Power Management. See Section 4.6 for more information.

Model DM100

Unit Name

Power Off…

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 64 65

Sem comentários

Dolby Laboratories DM100 Manual do Utilizador Página 10