
Dolby
®
DM100 User’s Manual Operation: Status Mode
3-27
3.2.5 Generator Status Display
Press [Enter] to display Generator status. The possible display
combinations are shown below:
See Section 4.2 for selecting stream and waveform names and
frequencies.
xxxx.x samples
The latency between the
output and input of the
DM100 in samples or ms.
Press [enter] to switch
between samples and time.
xxx.x ms
time
No Input
No AES3 input
N/A
Noise burst not received
within 1.5 times the max
latency setting.
The unit is generating a
non-PCM bitstream.
Generating
bitstream name
OR
The unit is generating a
PCM bitstream.
PCM name
OR
The unit is in
Pass Through mode.
blank
Pass Through
OR
The unit is in
Latency Test mode.
Measured Latency
OR
The unit is in
A/V Freq Drift mode.
A/V Freq Drift
Generator
ENTER to view
xxxxxHz –yydB
Waveform is Sine
or Square, Frequency and
level in dBFS.
F1—F2 –yydB
Waveform is Frequency
Sweep, Frequency range and
level in dBFS.
–yydB
Waveform is Pink or
White Noise, Level in dBFS.
N/A
Waveform is Silence.
xxxx samples
The difference in clock rate
between the AES input and
the Video reference input.
A continuous counter
indicates the drift of the
AES input with respect to
the video. A positive
number indicates the AES
input signal is faster than
the video reference. Press
[Enter] to reset the counter.
No Input
No AES3 input.
No Video
No video input.
Wrong Video Rate
Video present, but not
at 29.97 or 25 fps.
N/A
Waiting to make a reading.
Comentários a estes Manuais